How to Increase the Performance of Your Smok Pen
The Smok Pen is an electronic writing device that allows you to write in some recoverable format while you are smoking. If you do not know about the Smok Pen, it is a small electronic device that’s used like a pen, but rather of writing on paper you’re writing vapor on a cartridge and it sends that writing out through the cigarette. The Smok Pen works much like a real pen, except that you don’t have to hold the pen in your mouth like you would with a real pen. Instead, the pen is held in the hand so that you can write.
To have the Smok Pen working you will have to get some sort of power source. There are numerous choices for power, including batteries, wall outlets, USB cords, and of course the Smok Pen itself. To get the power to your Smok Pen, you will need to be sure you have a wall outlet available. Also you will want to be sure that you have a battery for the smoke pen. Usually a 22mm rechargeable battery will be sufficient for a good day’s writing. If you wish to go further you can purchase a charger and connect the pen to a USB port.
To be able to use your smok pen you will need to use a USB cable to connect your pen to your computer. The majority of the computers will charge your battery and it’ll be ready for writing immediately. However, if you have one of the newer computers that does not automatically charge your battery, you could have to press the energy button down for several minutes to ensure the battery is fully charged. Many of these newer computers will recognize when you are finished writing and will automatically shut off before it gets too hot to touch.
If you are going to use the Smok Pen at home, you need to charge the battery or keep it fully charged all the time. Since the Prolong warranty is for two years, you are not obligated to utilize the pen forever. However, since it is a top quality device you should at least continue steadily to charge the battery. You can do this by connecting the pen to your personal computer with the USB cord and then turning on the battery.
After the pen has been fired up, you will have to plug in the USB cord in to the computer. You will end up prompted to insert your charge card into the key pad. When you have completed this step, you can start the Smok Vaporizer and observe how your new pen gets hotter. You will notice that these devices starts to warm up within minutes. This is a great thing to watch since it indicates your new vaporizer is working properly.
The next thing is to turn up the pen and place the heating element in to the coil which is on the top section of these devices. The resistance value will undoubtedly be indicated on the device. You can begin to write on the paper which is located on the surface of the coil once the resistance value goes down. When you turn on the energy button on the Smok Vaporizer it is possible to see a screen to show you how many milliamps of power are being used.
In vapinger.com order to upgrade the performance of the Smok Pen, you will need to replace the airflow control component with a sub-ohm modulator. When you place the new coil into the pen, it’ll cause the airflow control to work differently. The Smok Vaporizer is well known for the ability to offer you constant and controlled vaporizing even at the highest wattage level. Both of these upgrades will allow you to enjoy even more of the positive benefits of the Smok Pen.
If you are not prepared to completely replace the batteries in your pen but wish to raise the maximum wattage and flavour then you will need to upgrade the wiring. Most pens should come with wiring already attached but if your pen does not, then you will have to connect the wiring to the negative rail on your modulator. After you have successfully attached the wires you can then attach the battery life and you will instantly notice a dramatic increase in the amount of flavour that is produced by your pen. The increased wattage alone ought to be enough to improve your confidence in this fun new electronic device.